Can't share stand
The requirements of the lighting installation specification are as follows:
1. Lamp Installation Specifications - Metal Halide Lamps
(1) The installation height of the lamp should be greater than 5 meters, and the wire should be connected to the lamp, but not close to the surface of the lamp.
(2) The lamp must be used in conjunction with the trigger and the current limiter, not alone, otherwise things will happen. (3) Protective measures should be taken for reflective lighting fixtures installed on the floor.
2. Lamp installation specification - general requirements
(1) When using steel pipe as the hanger of the lamp, the inner diameter of the steel pipe is generally greater than 10 mm; the thickness of the steel pipe wall is greater than 1.5 mm.
(2) The light wire of the hanging chain lamp should not be under tension. The light wire and the hanging chain are connected together, which is easy to use.
(3) Both ends of the flexible wire of the flexible wire chandelier should be protected by buckles, and the core wires at both ends should be tinned.
(4) For lamps installed in the same room or place, the deviation of its center line is within 5 mm, and the error should not be too long, otherwise it will affect the later use.
(5) Fluorescent lamps, high-pressure mercury lamps, and their accessories should be used together, and should be checked before installation and installed again after confirming that there is no problem.
(6) Fixtures of lamps must be firm. There are generally more than 2 screws or bolts for each lamp, which can be appropriately increased according to your own needs.