产品特点：
1.机械互锁设计，安全可靠：
2.插杆、拉杆尾部采用高频退火处理，方便二次加工安装孔；
3.此锁膜组件不但具有控制开模顺序功能，同时能控制合模顺序。
4.设计简洁，容易安装，操作时具有高度的可靠性，经试验和测试与Z171可以两选一使用。
Features:
1.mechanical interlocking design,safe and reliable.
2.Insert bar,end of pull rod adopt high frequency annealing treatment,so that easy to second time processing installed holes.
3.This latch parts not only control opeing mold sequence,But also control closed open sequecnce.
4.Designed simple,easy to install.The height is adjustable when operating.Test proved that you can choose one from z171
安装使用说明：
. 首先安装主体，要求平行于分型面安装；
. 安装拉杆，将拉杆截制成所需要的长度，并加工螺孔，在合模状态下锁紧螺丝（注意：拉杆固定前必须保证模具处于xx合模状态，并已xx拉杆与滚轮销之间间隙，再锁紧螺丝）；
.安装插杆，将插杆截制成所需要的长度，并垂直于分型面安装（注意保证几套锁模装置的行程一致）；
. 每套模具至少使用两套或两套以上的锁模机构并且对称安装，如未在模具上对称安装将可能导致单套锁模扣受力，受力不平衡（不均）将会导致 锁模扣断裂；
. 锁模扣零件为精密配合，请勿与其他自行加工的零件配合使用，由此带来的异常将由贵司自行负责;
. 如模具需要维修改动，请先拆除锁模装置后再进行后续操作;
. 在安装完毕后，请在合模机或注塑机上慢速进行开合模顺序测试，以确保正确无误。（不建议用吊机测试，因为吊机易不平衡）
Installation Guidelines:
. Please install the housing in parallel to the parting line first.
. Before install the control bar,please cut it to the necessary length ,form the bolt hole,Please tighten the screw when mold closed .(Please note:Make sure in a fully psition mold before fix the control bar,and eliminate the clearance between the control bar and locking roller).
. Pleace cut the latch bar to the necessary length,and installation in parallel to the parting line.
. Please install the latch lock symmetrically,otherwise,it would be fractured with the unbalanced force dueto only one side of locd set be forced,
. This latch locd is the precise standardized item,pplease do not apply together with other own customer machined parts.
. If mold need to maintain,please remove the latch locks first.
. After installed,carry out a functinal test,check whether the individual parts of the latch lock units moves soothly,the stroke is applicable.Recommend testing on matched Molds machine or lnjection machine,no Lifting Machine.
